Operation Manual

EN10
Activation/deactivation of the acoustic signal
After switching the hob on, press and hold the “-” of the first cooking zone and the external button on the right simultaneously for at least five seconds (“as shown
below”)
5 Sec
.
CLEANING
WARNING
- Do not use steam cleaners.
- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)
is not display
ed.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
• Sugar or foods with a high sugar content damage the hob and must be immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s instructions).
• Liquid splillages on the cooking zones may make pan vibrate or move.
• Dry the hob thoroughly after cleaning it.
TROUBLESHOOTING GUIDE
• Read and follow the instructions given in the section “Instructions for use”.
• Check that the electricity supply has not been shut off.
• Dry the hob thoroughly after cleaning it.
• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.
• If the hob cannot be switched off after using it, disconnect it from the power supply.
ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION
C81, C82
The control panel switches off
because of ex
cessively high
temperatures
The internal temperature of electronic
parts is t
oo high
Wait for the hob to cool down
before using it again.
C83
The control panel indicates the error
code hob off because of an issue on
elec
tronic circuit
Cooktop has been supplied with over
voltage
C
ooktop may be still used but call
the After-Sales Service
C85
Hob is not able to give power to
the pot
Pot is not suitable to the induction hob Use another induction pot
F02 or F04 or C84
The connection voltage is wrong or
issue to the po
wer supply
The sensor detects a discrepancy
betw
een the appliance voltage and
that of the mains supply
Disconnect the hob from the
mains and check the electrical
connection
F01, F05, F06, F07, F10, F12, F25, F33, F34,
F36, F37, F46, F47, F48, F49, F58, F61, F62,
F63, F72, F74, F77
Disconnect the hob from the power supply.
Wait a few seconds and plug it again.
If the problem persists, call the After-Sales Service and specify the error code