CA Cleaning Products Right to Know Act

6
Installation (continued)
6
Securing the canopy
7
Installing socket cap and
bulbs bulbs
□ Place the canopy (AA) over the mounting nipple (GG
),
and ensure it is flush with the ceiling.
□ Screw the ring (HH) onto the screw collar loop (II)
until the canopy (AA) is held firmly against the
ceiling.
□ Place the socket cap (E) onto the each sockets
(F).
□ Screw six 60-Watt maximum, incandescent
candelabra bulbs (sold separately) into the
sockets (F).
NOTE: You can use LED equivalent energy-saving
bulbs that do not exceed 8 Watts each (sold
separately).
Care and Cleaning
□ Clean the fixture with a soft, dry cloth.
□ Do not use any cleaners with chemicals, solvents or harsh abrasives.
WARNING: Before attempting to clean the fixture,
disconnect the power to the fixture by turning the
breaker off or removing the fuse from the fuse box.
Troubleshooting
Problem
Possible Cause
Solution
The bulb will not light.
The power is off.
Ensure the power supply is On.
The circuit breaker is off.
Ensure the circuit breaker is in the On
position.
The fuse blows or circuit
breaker trips when the light is
turned on.
The wires are crossed or
the power wire is
grounding out.
□
Check the wire connections.
□ Contact a qualified electrician.