Instructions / Assembly

9
INT_UE42V-SHB_INT195-YJ 19年2月14日 15:33
Installation (continued)
Balancing the Blades
All blades are grouped by weight. Because materials vary in
density, the fan may wobble even though the blades are weight
matched.
The following procedure should correct most fan wobble. Check for
wobble after each step.
Check that all blade and blade holder screws are secure.
Most fan wobble problems are caused when blade levels
are unequal. Check this level by selecting a point on the
ceiling above the tip of one of the blades. Measure this
distance as shown in Figure 14. Rotate the fan until the
next blade is positioned for measurement. Repeat for each
blade. Measurements should be within 1/8 in.
If blade wobble is still noticeable, interchanging two
adjacent (side by side) blades can redistribute the weight
and possibly result in smoother operation.
Figure 14
Touch Ceiling
Installing the Light Kit
WARNING: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan before
installing light kit.
CAUTION: Do not use pliers or screwdrivers to tighten
the thumb screws. Overtightening the thumb screws may
crack the lamp shades.
Install an LED bulb (max. 9.5W, medium screw base) to the
lampholder (Figure 15).
thumb sc
Install the lamp shade into the lamp fitter by tightening the
rews (Figure 16).
chain and fan pull chain. (Figure 16)
Attach the pull chain extensions provided to the light pull
Figure 15
LED Bulb
Lamp Holder
Figure 16
Lamp shade