Instructions / Assembly

8
Installation (continued)

sedal B naF eht gnihcattA
NOTE: Your fan blades are reversible. Select the blade side
above procedure could result in fan wobble.
Ƒ Mount the blade holders (D) to the fan blades (E) using the
screws (1) provided – 3 per blade (Figure 12). Please note
the rubber washers are pre-attached to the blade holder
(D).
The fan blade assemblies attach to the motor using the blade
holder screws (2) that are pre-installed into the blade holder (D).
The procedure to attach blade assemblies is as follows:
Figure 12
1
D
E
Ƒ
Position the blade holder (D) under the motor such that the
alignment post on the blade holder fits into the slot (3) in
the motor (Figure 13).
Tighten the pre-installed blade holder screws (2).
Repeat these steps to install the remaining blade
assemblies.
Ƒ
Ƒ
Figure 13
3
2
D
finish that best accentuates your decor. Failure to follow
INT_UE42V-SHB_INT195-YJ 19年2月14日 15:33