User's Manual
Privaris plusID Manager Operators Manual V1.0
Page 45 of 54 07.20.07
Appendix B
Overview of plusID Device Light Behavior
The plusID device has four indicator lights: green (top left), yellow (bottom left), red (top
right), and blue (bottom right).
Green, Yellow, Red and Blue…appear all at once for an instant.
The device is powering on.
Green, Yellow, Red and Blue…blink four times
The device is powering off.
Green, Yellow, Red and Blue….then solid red and device powers off
Indicates a non-enrolled device. If the device is enrolled, it indicates a function button
that has not been programmed with an access credential.
Blinking Green
The device is requesting a verification (fingerprint swipe).
Solid Yellow
The fingerprint sensor is processing a verification (fingerprint swipe).
Solid Green
Any successful fingerprint operation. During verification, solid green indicates a
successful fingerprint match. During enrollment, solid green indicates a completed
enrollment.
Solid Red
A failed fingerprint operation or a dead battery. During verification, solid red
indicates that the device cannot match the live fingerprint placed on the sensor with
the authorized users’ stored fingerprint template. During enrollment, solid red
indicates that the device was not able to capture enough data to successfully
complete enrollment.
A solid red light after powering on the device, followed by the device automatically
shutting off, indicates that the battery has been depleted and needs recharged
immediately.
Brief solid red…then blinking Green
During enrollment, the sensor did not get sufficient information from the fingerprint to
process the swipe. This often happens if the sensor is touched before a swipe is
begun, as opposed to placing the finger and swiping in one continuous motion.
When the device blinks green, try again.
Blinking Yellow
When disconnected from a computer, blinking yellow indicates a low battery (below
15%). The device needs recharged. When connected to a computer, blinking yellow
indicates that a device with a low battery (below 15%) is being recharged. The
blinking yellow will turn off when the battery is fully charged.