User's Manual

Privaris plusID Manager Operators Manual V1.0
Page 30 of 54 07.20.07
4. select a card format and “drag and drop” it into one of the four white
squares at the top of the screen that correspond to each of the device’s
four function buttons. Repeat as necessary.
! Only HID demo codes will work with battery powered HID demonstration readers
The demonstration card formats are reusable and can be removed (dragged from
a button to the on-screen trash can) and re-loaded as many times as desired.
8. Credentials: Using the plusID for Windows® Computer Logon*
If the plusID device will be used in place of passwords for computer logon in a
Microsoft domain environment, follow the instructions below.
With the device connected via USB to the plusID Manager application:
1. Select “Settings” from the menu tree. (See plusID Manager Operator’s
Manual for the distinction between “Settings” and “Default Device Settings”
menu options.)
2. Under “User Logon Settings,” select the desired authentication mode for
logon: PIN + Biometric or Biometric Only, and press “Apply Changes.”
3. If Biometric Only is chosen, instruct the user to enter “1234” when prompted
for a PIN during logon. Skip steps 4 – 9 below. Their plusID device is now
ready to be used for logon.
4. If PIN + Biometric is chosen, select “PINs” from the menu tree.
5. Select the “User” tab. This screen sets the User PIN required for logon and
stores it on the plusID device.
6. Enter the current (default) User PIN: 1234.
! This is different from the Administrator PIN that was entered when the device
was registered.
7. Ask the user to select a new User PIN (from four to eight letters, numbers
and/or characters).
8. Allow the user access to the keyboard to privately enter their User PIN.
9. Press “Change PIN” for the new User PIN to take effect.
* Logon requires Microsoft Windows 2000 Server or later configured as a domain controller and running
Microsoft Certificate Services, and the Privaris minidriver (included with Privaris plusID Manager
software). See Appendix E for a full description of system requirements.
! If the device is going to be used for logical/IT access only, and it has already been
enrolled, disconnect the plusID device from the computer, hand it to the user along
with the USB cable and plusID Quick Start Guide that was enclosed in the device
box. Device issuance is complete. If the device is also going to be used for physical
(door) access, see Section 7.