User's Manual

Privaris plusID Manager Operators Manual V1.0
Page 27 of 54 07.20.07
formats that are securely transferred to plusID devices using the plusID Manager
software.
a. Overview
If the plusID device will be used in place of access cards or fobs to access doors
and facilities, a physical access credential, in the form of a card format, must be
loaded onto the plusID device via the plusID Manager. This is done using an
HID idBank™, which is a smart card containing HID or Indala prox card formats
in quantities of 25, 50, 100, 200 or 300. All HID and Indala prox formats are
available. Additional formats will be supported in the future.
! Once a card format has been loaded on to a plusID device, it cannot be moved
off of the device back onto an idBank.
b. Loading a Card Format onto a plusID from an idBank
With the device connected via USB to the Enrollment Administrator’s
computer:
1. Connect a plusID device to the plusID Manager via USB
2. Register the device if it is not already
3. Connect a smart card reader to computer via USB (if not built into
computer).
4. Insert idBank in smart card reader
5. Select “Credentials” from the menu tree. The Credential Management
screen is displayed (Figure 8)
6. Select the “Card” tab under “Credentials Source.”
7. Select the appropriate smart card reader from the drop down menu.
The list of available card formats will be displayed. Previously
assigned card formats are sorted to the bottom of the list, grayed out
and the status is shown as “In Use.”
8. “Drag” an unassigned card format from the list and “drop” it in one of
the four white squares above (repeat as necessary). Each square
corresponds to one of the device’s four function buttons. A progress
bar is displayed as the credential is generated.
! Inform the user what doors/facilities are assigned to each of the
buttons (i.e., card formats) so that they will know what buttons to use
for daily access.