User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
58
58
Figure 7. 14 Add IPC Interface
3. You can take either of the following ways to add the network cameras.
Task 1: Add the Network Camera Searched Online
Steps:
1) Press the Up or Down Direction keys on the remote control to select the network camera.
2) Press the Enter key and then the Right Direction key on the remote control to enter the IP Camera No. item.
3) Confirm the parameters of the selected camera and enter the admin password of the camera.
4) Click the OK button to add the camera.
Task 2: Add the Network Camera Manually
Steps:
1) Use the remote control to enter the panel under the network camera list.
2) Configure the corresponding parameters, including IP Camera No., IP Camera Address, Manage Port, Channel
Port, Manufacturer and Admin Password of the camera.
3) Click the OK button to add the camera.
4. In the IPC Settings interface, the successfully added cameras will be shown. You can select the camera item and
click the Set IP button to modify the parameters according to actual needs.
5. If you want to delete the network camera, select the camera item and click the Delete button to remove it.
7.4 Configuring Serial Port
Purpose:
RS-232 and RS-485 are provided to be configured.
The RS-232 port can be used in two ways:
• Parameters Configuration: Connect a PC to the DVR through the PC serial port. DVR parameters can be
configured by using software such as HyperTerminal. The serial port parameters must be the same as of the
device when connecting with the PC serial port.
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]