User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
47
47
6.3 Configuring G-Sensor
Purpose:
G-Sensor is used for storing the acceleration information of triaxial directions during driving.
Before you start:
You need to connect an external sensor to the device for obtaining and providing the acceleration information of
triaxial directions.
Steps:
1. Enter the G-Sensor Settings interface, as shown in Figure 6.4.
Menu>Basic Settings>G-Sensor
Figure 6. 4 G-Sensor Settings Interface
2. Select the Module and set the alarm value for X Alarm, Y Alarm and Z Alarm.
Note: X, Y and Z represent the direction of acceleration and G (G=9.8 m/s
2
) is the unit of alarm value.
3. Configure the actions to handle the exception. Audio Alarm and Trigger Alarm Output are available. Please see
Chapter 7.2.2 for alarm output configuration.
4. Click the OK button to save the settings and exit.
Note: The status of G-Sensor can be checked in G-Sensor Status interface (Menu>Status>G-Sensor).
6.4 Configuring Sensor-In
Purpose:
Sensor-In can be used for collecting driving information of the vehicle, including pedal braking, turning left/right,
reversing, etc.
Before you start:
You need to connect an external traveled recorder to the device for obtaining and providing the driving information
of the vehicle.
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]