User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
34
34
4) Press the Direction key on the remote control to adjust the size of the block and press Enter key to save the
setting.
Note: You can press the A button on the remote control to clear all the mask areas.
5) Press the Menu key on the remote control to set sensitivity. You can set the level from 1 to 6, and off is also
selectable. Click the OK button to save and exit.
6) Press the Enter key on the remote control to save the settings and then press ESC key to exit.
3. Click the Handle button for Motion Detection to set arming schedule and alarm response actions, as shown in
Figure 3.4.
Alarm response actions:
• Pop-up Image on Monitor:
When an alarm is triggered, the local monitor displays in full screen the video image from the alarming
channel configured for full screen monitoring.
• Audio Warning:
Trigger an audible beep when an alarm is detected.
• Trigger Alarm Output:
Trigger an alarm output when an alarm is triggered. Please refer to Chapter 7.2.2 for alarm output
settings.
Figure 3. 4 Motion Detection
4. Click the Set button for Triggered Camera to select the channel to be triggered.
5. After configuration of motion detection, enter the Record Settings interface to set motion detection record. Please
see Chapter 3.1.2 for record settings (set the Type to motion detection).
3.3 Configuring Alarm Triggered Record
Purpose:
Follow the procedure to configure alarm triggered recording.
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]