User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
33
33
to Chapter 3.2 & 3.3 for motion and alarm recording.
6) Click the OK button to save the settings and exit.
Note: Up to 8 periods can be configured for each day. And the time periods can’t be overlapped each other. You can
enter the Record Status interface (Menu>Status>Record) to check the recording status.
Figure 3. 3 Record Schedule Interface
5. Click the Set button for More Settings to configure the pre-record and post-record. Click the OK button to save
the settings and exit.
Pre-record: The time you set to record before the scheduled time or event. For example, when an alarm triggered
the recording at 10:00, if you set the pre-record time as 5 seconds, the camera records it at 9:59:55.
Post-record: The time you set to record after the event or the scheduled time. For example, when an alarm
triggered the recording ends at 11:00, if you set the post-record time as 5 seconds, it records till 11:00:05.
6. If the settings can also be set to other channels, click Copy.
3.2 Configuring Motion Detection Record
Purpose:
In the live view mode, once a motion detection event takes place, the device can analyze it and do many actions to
handle it. In this chapter, you can follow the steps to schedule a record which triggered by the detected motion.
Steps:
1. Enter the Advanced Camera Settings interface.
Menu>Other Settings>Camera>Set (for More Setting)
2. Check the checkbox before Motion Detection and click the Area Settings button for Motion Detection to set the
areas for motion detection.
Steps:
1) Press the Edit key on the remote control and a red block appears on the screen.
2) Press the Direction key on the remote control to adjust the position of the red block.
3) Press the Enter key on the remote control to save the position of the red block.
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]