User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
31
31
3.1 Configuring Encoding Parameters
3.1.1 Initializing HDDs
Before recording, make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
Steps:
1. Enter the HDD Management interface, as shown in Figure 3.1.
Menu>HDD
Figure 3. 1 HDD Management Interface
2. Select HDD to be initialized. If the hard disk is installed correctly and formatted, the status is normal or sleeping.
3. Set the Overwrite to Yes or No.
Note: By default the overwriting function is enabled. If you set the Overwrite to No, the recording stops when the
hard disk is full.
4. You can also check the information by viewing S.M.A.R.T information.
3.1.2 Configuring Record Settings
Purpose:
You can configure the transmission stream type, the resolution, frame rate, etc.
Steps:
1. Enter the Record Settings interface, as shown in Figure 3.2.
Menu>Basic Settings>Record
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]