User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
19
19
contact A and B of the Alarm Output will be closed. Therefore, the active alarm device must be connected.
Figure 1. 8 Alarm Output Connection
Please follow the procedure below:
Steps:
1. Disconnect pluggable block from the ALARM IN /ALARM OUT terminal block.;
2. Unfasten stop screws from the pluggable block, insert signal cables into slots and fasten stop screws. Ensure
signal cables are in tight;
3. Connect pluggable block back into terminal block.
1.6 Hard Disk Installation
Notes:
1. A factory recommended HDD should be used for this installation.
2. After installation, please initialize the HDD before recording. Please refer to Chapter 3.1.1 for detailed
information.
3. Please disconnect the power before and during the hard disk installation.
Steps:
1. Prepare the tools required: 2.5-inch hard disk,
anti-static gloves, key to hard disk lock, screwdriver and
screws.
2. Insert the key and turn in counterclockwise direction to
open the hard disk lock (the hard disk lock is locked when
keyhole is upward and unlocked when keyhole is
leftward), unfasten the screws counterclockwise and pull
out the hard disk box.
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]