User manual

User Manual of DS-8100HMFI-TH Series Mobile DVR
16
16
1. Run the Client Management System to check and remember device ID#.
2. The default ID# is 255. This ID# is valid for all the IR remote controls.
3. Press the DEV button on the remote control.
4. Enter the device ID# from step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the Status indicator does not
turn blue and there is still no response from the remote, please check the following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
If the remote still can’t function properly, please change a remote and try again, or contact the device provider.
1.4 Starting Up and Shutting Down the DVR
There are two ways to start up DVR: Startup with vehicle ignition and time-delay shutdown, and auto on/off.
1.4.1 Vehicle ignition startup
There are two kinds of vehicle ignition switch: positive pole ignition switch and negative pole ignition switch.
For detailed time-delay shutdown, please refer to Chapter 6.1.
Note:
1. Please contact the vehicle manufacturer for the information about the connecting mode of starting switch.
2. Positive pole ignition switch is used by most cars.
Positive pole ignition switch
Figure 1. 4 Positive Pole Ignition Switch
Ignition switch is connected to the positive pole of DC+12/24V of vehicle batteries. Please make sure that the
Lo-Call 1890 866 900
www.cctvireland.ie
[e-mail]