Specifications

144

• BVR playback speed now more accurately reflects the position of the playback speed

control slider

• Several potential bugs affecting the use of the "run as service" option have been

repaired

• Support for ACTi MJPEG cameras (requires firmware update)

2.33

• An alternate phone# may be entered on the Telephone Alert (See 7.5) page to be used

in the case of Watchdog Timer (See 7.10) alert.

• For each motion sensor (See 7.3) profile, you may choose to NOT trigger alerts when the

motion sensor is triggered. Used with the Schedule (See 7.8) page, this allows you to

specify times during the day during which to record on motion but not send alerts.

• Several new IP cameras added

2.32.05

• Fix to allow Microsoft LifeCams to properly set their resolution

• The camera limit has been changed from 25 to 64. Please be aware that Blue Iris will

not prevent you from attempting to exceed your system's resources. You should not

operate your system at 100% CPU or HDD utilization for any extended period of time to

ensure proper operation and UI responsiveness.

2.32.04

• Fix for Panasonic BB-HCM311/71 and Panasonic KX-HCM110 ADPCM audio decoding. If

there are other G.726/ADPCM cameras which also have audio-clarity issues in Blue Iris,

please bring this to my attention, ken@blueirissoftware.com

2.32.02

• When the interface reappears after having been minimized, previously an old video

frame may have been visible until a new frame is drawn

• The motion detector may have been activated if the software was started during a

period where the schedule should have de-activated it

2.32.01

• The email alert JPEG attachment should now be guaranteed to contain a frame which

caused the motion sensor to trigger. Previously, Blue Iris used the current frame from

the camera at the time of the actual email.