Installation Guide

TIMER
Controls the Timer.
9 Settings: (1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h,9h)
Press button until reach desired setting.
TEMPERATURE
1. Press once: Touch panel indicator becomes
active.
2. Press again until desired setting is reached.
Digital display shows setting circles as
below.
NOTE: Press the button for 10 seconds,
the temperature setting will switch from °C
to °F. Same way from °F to °C.
WARNING: Do not move or remove the mesh trim panel, when the appliance is plugged in
and operating. This will cause the remote control and touch panel to no longer function.
Remote Control Battery Information
This remote control uses two AAA batteries.
Instructions for battery installation are on the Remote Control battery compartment.
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an explosion.
Dispose of batteries at your local hazardous material processing center.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the
buttons too quickly. Give the unit time to respond to each command.
NOTICE
When the heater is first turned on, a slight odor may be present. This is normal and should not
occur again unless the heater is not used for a long period of time.
Display Value
0
1
2
3
4
...
12
13
14
15
N
Temperature
°C
17
18
19
20
21
...
27
28
29
37
ON
°F
62
64
66
68
69
...
80
82
84
99
ON