Installation Guide

【Power】
Plug the power cord into a 110-120 Volt 15 Amp outlet. Make sure the outlet is in good condition and
that the plug is not loose. NEVER exceed the maximum amperage for the circuit. DO NOT plug other
appliances into the same circuit.
【Temperature Limiting Control】
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature(212°F/100°C), the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait at least 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use
a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If it switches off again, UNPLUG THE HEATER RIGHT AWAY! Have the outlets, wiring, and
breaker box inspected by a professional. Make necessary repairs before using the heater.
【Heater Rating】
Maximum Heat Output: 1500W (5120BTU); Maximum Heating Area: 400 square feet.
【To switch on】
Plug in the appliance into the socket. Turn on the Power Switch
The control Switch Panel is on the bottom of tempered glass panel (See pic)
Control Switch
Panel
Read and understand this entire owner's manual, including all safety information, before plugging
in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death.
OPERATIONS