Installation Guide

B. Recessed Functional Fireplace Installation
Step 1: Take off the six silver screws, then remove the wall kit on the both side, and take off the
tempered glass by two hands carefully
Step 2: Put the fireplace insert into the available hole, then fix the 6
ST4*40
screws on both sides.
The next step requires installation of a Glass panel! The manufacturer recommends that two adults install
the glass panel. Always use extremely caution when handling glass. Failure to do so could result in
personal injury or property damage.
Carefully set both hooks of the front glass panel onto the firebox. Note: make sure the glass fully attached to the
firebox so that the control panel can work properly. This will keep the decorative glass in place and enable the
control panel work well.
Figure C
Note: Put the crystals on the plastic board as Figure C