Installation Guide

2
sensory or capabilities, or lack of experience and knowledge unless they have been given
supervision or instruction concerning the use of the appliance by a person responsible for their
safety.
➢ Children should be supervised to ensure that they do not play with the appliance.
➢ CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by the utility.
➢ NEVER permanently install in a recessed area of the wall. This may result in blocked air
flow, overheating, or fire.
➢ WARNING: DO NOT DEPEND ON THE POWER SWITCH THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER. ALWAYS
UNPLUG THE POWER CORD.
➢ WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK---DO NOT USE THIS
HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES.
➢ This product is not intended to be a primary heat source. It is for supplemental heat ONLY.
➢ NEVER modify this heater. Doing so could result in personal injury or property damage.
➢ Modification of this fireplace completely voids all warranties.
ONLY use this heater on a 120V AC 15-Amp circuit. NEVER overload the circuit. If this heater
trips the circuit breaker, unplug all other appliances on the same circuit before the next use.
➢ Avoid plugging other appliances into the same circuit as this heater.
ALWAYS check your heater cord and plug connections with each use!
➢ MAKE SURE the plug fits tightly in the outlet! Faulty wall outlet connections or loose plugs can
cause the outlet to overheat.
➢ Heaters draw more current than small appliances. Overheating may occur even if it has not
occurred with the use of other appliances.
➢ During use check frequently to see if the plug outlet or faceplate is HOT!
➢ If the outlet or faceplate is HOT, discontinue use immediately and have a qualified electrician
inspect and/or replace the faulty outlets.
➢ This heater has a polarized plug (one blade is wider
than the other). As a safety feature to reduce the risk
of electrical shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat
this safety feature.
➢ SAVE THESE INSTRUCTIONS!