Installation Guide
【Instruction for Remote Controller and Switch Panel】
Flame setting
Top light setting
Brightness And Top Light Setting
Power ON/OFF
Heat setting
Speaker setting
Control Panel / Remote Control Operation
(Control panel POWER switch must be ON to use remote control.)
The touch display panel is shown by LED's on the front bottom right of the appliance. The LED's will
appear on the bottom of the fireplace control panel.
POWER
Turns the appliance ON/OFF.
FLAME
Controls Flame colors.
6 colors flame.
FLAME - Log
Controls Log Flame change.
13 colors
.
HEATER
Controls the Heater.
Press button to initiate the heater.
(OFF) no heater or blower.
(LO), heater blows warm air (750W)
(HI), heater blows hot air (1500W)
NOTE: Heater functions cycle from OFF-LO-HI
Brightness
Top Light
Brightness: L1-L2-L3
Top Light: L4-L5-L6
Log Speaker
The log speaker can make the real log burning effect.
Press first time to turn on the log speaker,
Press second time to turn off the log speaker.
WARNING : Do not move or remove the mesh trim panel, when the appliance is plugged in and
operating. This will cause the remote control and touch panel to no longer function.