Installation Guide

7
Plug the power cord into a 110-120 Volt 15 Amp outlet. Make sure the outlet is in good condition and that the
plug is not loose. NEVER exceed the maximum amperage for the circuit. DO NOT plug other appliances into
the same circuit.
⚫ Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature (212°F / 100°C), the heater will automatically turn OFF.
To reset:
1. Unplug the power cord from the outlet
2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait at least 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum
to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If it switches off again, UNPLUG THE HEATER RIGHT AWAY! Have the outlets, wiring, and breaker box
inspected by a professional. Make necessary repairs before using the heater
⚫ Heater Rating
Maximum Heat Output: 1500 W (5120 BTU)
Maximum Heating Area: 400 square feet.
⚫ Remote Control /Switch Panel Instruction
Temperature setting
Timer Setting
Top light setting
Power ON/OFF
Heat setting
Flame setting
(Control panel power switch must be ON to use remote control.)
Operation