Installation Guide

Step 1

Step 2

Step 3

Step 4

⚫ Recessed Fireplace Style

1. Remove the wall bracket first.Take off the 4 silver screws (ST4*8-screw) on the top and then take off the wall

bracket from the fireplace.

2. Take off the 2 silver screws (ST4*8-screw) on the left side and right side, then pull out the front glass panel from

the fireplace.

3. Put the fireplace into the hole, then fix the 2 silver screws( ST4*40-screw) as the photo from the inside of the

fireplace.

4. Put the plastic tray, and put on the crystal and drift wood fire logs.

5. Put the glass panel onto the fireplace directly. Make sure the front of the firebox is not lower than the surface of

the wall. Carefully set both hooks of the front glass panel onto the firebox.

Step 5

Take care of the installation of a Glass panel!

We recommends that two adults install the glass

panel. Always use extreme caution when handling

glass. Failure to do so could result in personal injury

or property damage.

Note: make sure the glass is fully attached to the

firebox so that the control panel can work

properly. This will keep the decorative glass in

place and enable the control panel to work well.