Specifications

SECTION 4

MAINTENANCE

6. If you are replacing or re-installing the Service Station, please see the section titled

“Installing the Service Station”.

7. If you are cleaning or replacing items in the service station; please see the next section titled

“Cleaning the Service Station”.

Cleaning the Service Station

Caution: Please be sure that you are using proper cleaning techniques to clean items that come in contact

with the printhead. Use only distilled or deionized water and lint free cloths. If you don’t follow this rule,

you will introduce contamination into the printhead; which can damage the printhead and ink system.

Wiper Roller Removal and Cleaning or Replacement

Tip: Although the wiper roller can be cleaned; this process is time-consuming. When you factor in labor

costs; you may find it more cost-effective to replace the wiper roller instead. We also recommend that the

wiper roller be replaced whenever a new printhead is installed.

Removal:

1. Lift up, about one inch, on the Wiper Motor Assembly; to expose the

latch retaining screws [C] (one at each end).

NOTE: Early versions of this assembly did not have retaining screws.

2. Carefully loosen the two small screws retaining the wiper roller latches.

Tip: To avoid loosing these screws; don’t remove the screws. You only

need to back-out the screws far enough so the latches can be opened.

3. Release the two latches that secure the wiper roller.

4. Remove the Wiper Roller from the Wiper Motor Assembly.

Wiper Motor Assy