Specifications

SECTION 4

MAINTENANCE

Service Station

Slot

Removing the Service Station

1. Open the Top Cover

2. Open the Ink Tank Door (hinged at bottom) to expose

the “Service Station Slot”.

Tip: On older units

you will need to

remove the Exit

Roller Cover by

removing the four

(4) screws. This is

not necessary on

newer units.

3. Power-up the printer.

4. Open the Printer Toolbox. In the User

Interface window, press the “Eject

Service Station” button.

5. Once the Service Station has ejected; power OFF the printer. Press the ON/OFF button once and

wait about 45 seconds for the print engine to power off (all control panel light’s off). Then turn the

Main Power Switch OFF.

6. Slide the Service Station out of the Service Station slot.

CAUTION: Do not pull Station all the way out until you

disconnect the Ribbon Cable.

NOTE: It is a good idea to place an absorbent towel

under the Service Station as you remove it to prevent any

drips or leaks.

4. Disconnect the Ribbon Cable. Slide the Latch open on

the Service Station Circuit Board to release the Ribbon

Cable.

CAUTION! This latch can be broken if you pull it out

too far. Be careful!

5. Remove the Service Station completely from the print

engine and place it on a non-absorbent surface (plastic

bag) to protect the surface you are placing it on.

Ink Tank

Door