User`s manual

78
Chapter 2 Cleaning
NOTE: After a form feed, the position of the leading edge of the next label
depends on the type of Media Handling mode selected under the
QUICK SETUP menu. Tear-Off and Tear-Off Strip Media Handling
positions the label edge at the tear bar, while Continuous positions
the label edge under the printhead.
12. Once the correct values are confirmed, save them to the desired
configuration menu before powering off the printer. See “Saving A
Configuration” on page 84.
Cleaning
Depending on the media used, the printer may accumulate residues (media
dust, adhesives, etc.) as a by-product of normal printing. To maintain top
printing quality, you should remove these residues by cleaning the printer
periodically.
General Cleaning
Perform a periodic cleaning on all rollers, guides, and assemblies. Low
pressure air can be used to remove dust in the printer. Isopropyl alcohol and a
cotton swab should be used to clean any areas where media dust, adhesives,
etc. have accumulated. The media path and printhead should be cleaned
each time a new roll of media is installed in the printer.
Printhead Cleaning
As you use your printer, the printhead may become dirty which can result in
poor print quality. You should clean the printhead each time you install new
ribbon (thermal transfer print mode) or install new media (direct thermal print
mode). Clean the printhead with the cleaning pen supplied with the printer.
By keeping your printhead clean, you will help maintain its life.