User`s manual

366
Appendix F
Zebra Xilll Series T5000e with PPI1 Emulation
Media Type - Continuous*, Non-Continu-
ous.
Sensor Type -
Web - Liner gap, notch or hole. NOTE: Media
Type must = Non-Continuous.
Mark - Black mark on underside of label
(Media Type must = Non-Continuous).
QUICK SETUP Menu,
Gap/Mark Sensor-
Disable*- Same as Zebra Continuous Media Type (no
label length indicators).
Non-Continuous N/A. Assumed when Gap, Adv Gap or
Adv Notch selected.
NOTE: Use Gap, Adv Gap or Adv Notch for Zebra Web.
NOTE: No Media Type setting is available or required.
Gap - Liner gap, notch or hole.
Adv Gap - Use w/dark background labels
Adv Notch - Use with dark background labels.
Mark - Black mark on underside of label. No Media Type
setting avail. or required.
Print Method –
Transfer*- Use of ribbon.
Direct - No ribbon used.
QUICK SETUP Menu,
Print Mode - Transfer* or Direct.
Print Width - Width of image to be printed in
Inches, MM or Dots.
Printer width dependent.
QUICK SETUP Menu,
Label Width - Width of image to be printed in Inches or
MM.
Printer width dependent.
Label Length - Printable length of label in
Inches or MM.
QUICK SETUP Menu,
Label Length - Printable length of label in Inches or MM.
Maximum Length - Used to assist in media
calibration only.
CALIBRATE CTRL Menu,
Use Label Length – (Enable*) Uses Label Length value
in QUICK SETUP menu to assist in Auto Calibrate
procedure.
Parallel Comm. -
Parallel*
Twinax/Coax (option)
PARALLEL PORT Menu,
Port Type - IEEE 1284*, Disable or Centronics. NOTE:
Use C/T PORT Menu if Coax/Twinax option installed.
Serial Comm. -
RS232*, RS422/485 or RS485 multidrop.
SERIAL PORT Menu,
Port Type -
RS232*, RS422 or Disable.
Baud - (110 - 57600) 9600* Baud Rate - (600 - 115200) 9600*
Data Bits - 7-bits* or 8-bits
Word Length 7 or 8*
Parity - (Even*, Odd or None) Parity - (Even, Odd or None*)
Stop Bits - 1 stop bit* or 2 stop bits Stop Bits - 1* or 2
Host Handshake -
XON/XOFF*, DTR/DSR
Protocol - None*, Zebra or ACK/NAK
Data Protocol -
XON/XOFF*, ETX/ACK, ACK/NAK, Series 1 Char, Series
2 Char or DTR
Table 32: PPI1 Menu (continued)