User`s manual

ETHERNET PARAMS Submenus
271
Ethernet Speed
This menu appears only if a 10/100Base-T Network Interface Card (NIC) is
installed.
The Ethernet Speed menu has five different speed modes to allow
compatibility with different systems and networks:
• Auto Select. Tells the 10/100Base-T NIC to perform an auto detection
scheme and configure itself to be 10 Half Duplex, 10 Full Duplex, 100 Half
Duplex, or 100 Full Duplex.
• 10 Half Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
• 10 Full Duplex. Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
• 100 Half Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
• 100 Full Duplex. Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
The factory default is Auto Select.
Job Control
• Standard. The NIC waits for the entire job to be received before it
indicates the job is done.
• Enhanced. The NIC waits for the entire job to be printed before it
indicates the job is done.
• Off. There is no synchronization between the NIC and the printer.
The factory default is Standard.
NOTE: For detailed information about using the NIC, refer to the
Network
Interface Card User’s Manual
.