User`s manual

Overview
235
Scalable Size
(From page 176.) This option determines whether scalable characters are
sized based on normal scaling or based on the size of block characters. If the
option Block is set, then the scalable character are made to be the same size
as block characters in the old IGP-X00 printers.
The options are Normal (the factory default) and Block.
SCS Buffer Cntrl
(From page 158.) This option functions like the Early Print Complete feature
(“Early Print Cmpl (Coax, TN3270)” on page 212) but is for SCS only.
• Don’t Wait. The printer does not wait until the buffer is printed before
sending the print complete back to the host.
• Wait Until Done. The printer waits until the buffer has printed before
sending the print complete back to the host.
NOTE: If set to Wait Until Done, printer speed may be reduced.
The factory default is Don’t Wait.
Select Char
(From page 176.) Instructs the IGP which decimal character (0-255) to ignore
from the host.
The range is 0-255, and the factory default is 0.
Select CPI
(From page 184, page 187, page 189, page 191, page 193.) This item selects
the characters per inch (CPI) value.
The options are 10.0, 12.0, 13.3, 15.0, 17.1, and 20.0 CPI.
The factory default is 10.0 CPI.
Select LPI
(From page 175, page 184, page 187, page 189, page 191, page 193.) This
is the number of lines to be printed per inch. For example, at 6 lpi there is
1/6 inch from the top of one print line to the top of the next print line.
The options are 6.0, 8.0, and 10.3 LPI.
The factory default is 6.0 LPI.
Select SFCC (PGL)
(From page 175.) You can specify which decimal code (1-255) will be used as
the Special Function Control Code (SFCC). The SFCC denotes that the
following data is a PGL command.
The range is 1-255, and the factory default is 126.