User`s manual

Overview
229
Offpage Errors
(From page 179.)
• Disable. Does not report errors for elements that start or end beyond the
right edge of the page.
• Enable. Reports errors for elements that start or end beyond the right
edge of the page.
The factory default is Disable.
Optimized Ratio
(From page 175.) This option selects different bar code ratios for certain bar
codes including Code 39 and Interleaved 2 of 5. It is included for compatibility
with the IGP-X00 printers.
• Disable. Use standard bar code ratios.
• Enable. Select the alternate bar code ratios.
The factory default is Disable.
Overstrike
(From page 185, page 190.) Overstrike determines the action required when
a line is printed over a previous line because a carriage return was received
without a line feed.
• Enable. Prints the second line on top of the first line.
• Disable. Replaces the characters from the first line with the second line.
The factory default is Enable.
PA1
(From page 158, page 164.) PA1 is only valid when the printer is in the offline
state and the coax Systems Network Architecture Character Set (SCS) data
stream is active. This function displays the “PA1 ENABLED” message when
the ENTER key is pressed, and sends a special operator request to the host
when the printer is put back online. Refer to the
Coax/Twinax Programmer's
Reference Manual
for more information about SCS.
NOTE: Selecting PA1 again (“PA1 DISABLED” appears on the operator
panel) or selecting PA2 will reset the pending PA1 function.
PA2
(From page 158, page 164.) PA2 is only valid when the printer is offline and
the coax SCS data stream is active. This function displays the “PA2
ENABLED” message when the ↵ key is pressed, and sends a special
operator request to the host when the printer is put back online.
NOTE: Selecting PA2 again (“PA2 DISABLED” appears on the operator
panel) or selecting PA1 will reset the pending PA2 function.