User`s manual

Overview
227
• PPI1 Quiet. All data and PPI commands are passed to the LP+
emulation.
For information on setting the LP+ Text Mode through the host data stream,
refer to the
PPI1 Programmer’s Reference Manual .
The factory default is Absorb.
LPI
(From page 178.) This item selects the number of lines printed per inch.
The range is 6-10, and the factory default is 6.
Max PI 16
(From page 180.)
• Enable. A paper slew of 0-15 will move 1-16 lines.
• Disable. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will
always move 1 line.
The factory default is Enable.
Max. Print Width
(From page 159, page 161, page 171, page 173.) Set the maximum print
width the printer will print when using a C/T or TN5250 host interface. Set for
13.2 inches when printing files larger than the width of the printer. All data
exceeding the width of the maximum Printer Width will be truncated.
• 13.2 inches
• Printer Width (the maximum width of the printer)
The factory default is 13.2 inches.
MC Label Fmt
(From page 181.) The ^MC command determines whether the printed label
image should be retained for use in the immediately following label definition.
The MC Label Fmt option determines the internal format to be used for storing
the label image: list format or bitmap format.
• List format. Works for most applications and should be used for
applications where memory is sufficient.
• Bitmap format. Should be used in applications where a large amount of
data is sent. Bitmap format has greater efficiency of memory use. The
label image of the next label is overlaid on the bitmap of the current label
(instead of accumulating a list of stored print elements like List Format,
which might eventually run out of memory in a large print job).
The factory default is List Format.