User`s manual

Chapter 3 Emulation Submenus

Host Form Length (PGL)

(From page 175.) Determines how the physical label length (see Label Length

under the MEDIA CONTROL menu) is affected upon receiving an EXECUTE

command.

• Enable. The physical label length will change to match the form length

(specified in CREATE command). The physical label size remains at the

new setting until another EXECUTE command is received, or the

PRINTER CONTROL menu settings are changed.

• Var. Length. The physical label length is the longest print element plus

the setting of “Var Form Adjust.”

• Var Dynamic Len. The physical label length will change to the longest

print element defined in CREATE mode plus the setting of “Var Form

Adjust.”

• Disable. Forms printed in EXECUTE mode do not change the physical

label size. Therefore, the size of the form (defined in CREATE mode)

must fit within the current label dimensions, or errors may occur.

NOTE: Changing the form length via the EXECUTE command changes the

LP+ Emulation logical dimensions.

The factory default is Enable.

Host Form Length (IPDS)

(From page 166.) Enables or disables changing the form length by the host.

• Disable. The host is unable to change the form length.

• Enable. The host may change the form length.

The factory default is Disable.

Host Form Length (PPI1)

(From page 181.)

Selects whether the Label Length set in the menu or sent by the host software

command is used.

• Enable. Label length will be determined by the ^LL command if it is

present. If the ^LL command is not present, it will be based on the Label

Length value in the QUICK SETUP or MEDIA CONTROL menu.

• Disable. Label length will be determined by the Label Length value in the

QUICK SETUP or MEDIA CONTROL menu.

The factory default is Enable.