User`s manual

Overview
199
Autoeject (VGL)
(From page 178.) Determines paper handling upon exiting the VGL Repeated
Form and Dynamic Form commands.
• Disable. Holds the print position at the bottom of the form.
• Enable. Issues a form feed after the last form is printed so all pages will
be physically printed.
The factory default is Disable.
Autowrap
(From page 175.) This parameter determines if text will wrap to the next line
when the line of text exceeds the right margin.
• Disable. Truncates the text beyond the right margin until a CR or CR + LF
is received.
• Enable. Automatically inserts a CR + LF after a full print line.
The factory default is Disable.
AX Fine Adj. CMD
(From page 183.) This option allows you to choose whether the engine
command for a position fine adjust (AX) should be processed or ignored.
When you select “Ignore,” the paper will not be fine-adjusted.
The factory default is Process.
AY Intensity CMD
(From page 183.) This option allows you to choose whether the engine
command to set the print intensity (AY) should be processed or ignored. If you
want to adjust the print intensity through the front panel, use this menu to
prevent the host commands from overriding these settings. When you select
“Ignore,” the AY command will be ignored and “Print Intensity” as configured
in the “MEDIA CONTROL” menu will be used.
The factory default is Process.
Barcode Errors
(From page 179.)
• Enable. An error message will print when invalid bar code data is
encountered.
• Disable. VGL will not print an error for illegal bar code data; the bar code
will be skipped.
NOTE: When Barcode Errors is disabled, the VGL emulation will try to make
the best use of invalid data by either truncating extra digits or adding
zeros to the end of bar code data to meet minimum data length
requirements for some bar codes. Not all errors will be corrected.
The factory default is Enable.