User`s manual

194
Chapter 3 EPSON FX SETUP
Define CR code
(page 210)
CR = CR* CR = CR + LF
Define LF code
(page 211)
LF = LF* LF = CR + LF
Printer Select
(page 232)
Disable* Enable
20 CPI Condensed
(page 195)
Bold
(page 200)
EPSON FX SETUP
(cont. from prev. page)
Text Position
(page 241)
Bottom of Line* Top of Line
Auto LF
(page 198)
Enable* Disable
Host Command
(page 219)
Enable* Ignore All Ignore CPI Ignore LPI
Alt. Set 80-9F
(page 197)
Control Code* Printable
(1)
Enable* Disable
Disable* Enable
Print Char. Set
(page 232)
Bottom Margin
(page 200)
0* linespaces 0-451 linespaces
Reset Cmd CFG Ld
(page 234)
Disable* Power up config Current config Factory config
Form Length
(2)(3)
(page 216)
Form Length
(2)(3)
(page 216)
101.6 or 152.4 mm*
(4)
Form Length
(2)
(page 216)
Form Width
(5)
(page 217)
41, 66, or 85 characters*
(4)
0 to 272 characters
00.0 to 609.6 mm
4 or 6 inches*
(4)
00.0 to 24.0 inches
24 or 36 lines*
(4)
0 to 144 lines
Form Width
(3)(5)
(page 217)
104.1, 168.0, or 215.9 mm*
(4)
00.0 to 345.4 mm
Form Width
(3)(5)
(page 217)
04.1, 06.6, or 08.5 inches*
(4)
00.0 to 13.6 inches
Notes:
* = Factory Default
1
When the CTHI option is installed,
the factory default is Printable.
2
All three Form Length submenus
work in conjunction. When you
change the default in one
submenu, the default values in the
other two submenus change
automatically.
3
These menus do not display when
the CT, TN5250, or TN3270
emulation is selected.
4
The factory default value depends
on the width of the printer model.
5
All three Form Width submenus
work in conjunction. When you
change the default in one
submenu, the default values in the
other two submenus change
automatically.