User`s manual

188
Chapter 3 P-SER XQ SETUP
Compressed Print
(page 208)
Char 01 SOH*
Bold
(page 200)
Elong/Alt. Font
(page 212)
Disable* Enable
Gothic Typeface
(page 217)
EVFU Select
(page 214)
Enable* Disable
Upr. Case Select
(page 244)
Slew Relative
(page 239)
1 to 16 lines1 to 15 lines*
P-SER XQ SETUP
(cont. from prev. page)
Text Position
(page 241)
Bottom of Line* Top of Line
Char 03 ETX Char 09 HT
Elng=BS Font=SO* Elng=SO Font=BS
Char 02 STX* Char 03 ETX Char 09 HT
Disable* Enable
Reset Cmd CFG Ld
(page 234)
Disable*
Host Command
(page 219)
Enable* Ignore All Ignore CPI Ignore LPI
Power up config Current config Factory config
Control Code 06
(page 209)
8.0 LPI* 10.3 LPI 6.0 LPI
Form Length
(1)(2)
(page 216)
Form Length
(1)(2)
(page 216)
101.6 or 152.4 mm*
(3)
Form Length
(1)
(page 216)
Form Width
(4)
(page 217)
41, 66, or 85 characters*
(3)
0 to 272 characters
00.0 to 609.6 mm
4 or 6 inches*
(3)
00.0 to 24.0 inches
24 or 36 lines*
(3)
0 to 144 lines
Form Width
(2)(4)
(page 217)
104.1, 168.0, or 215.9 mm*
(3)
00.0 to 345.4 mm
Form Width
(2)(4)
(page 217)
04.1, 06.6, or 08.5 inches*
(3)
00.0 to 13.6 inches
Notes:
* = Factory Default
1
All three Form Length
submenus work in conjunction.
When you change the default
in one submenu, the default
values in the other two
submenus change
automatically.
2
These menus do not display
when the CT, TN5250, or
TN3270 emulation is selected.
3
The factory default value
depends on the width of the
printer model.
4
All three Form Width submenus
work in conjunction. When you
change the default in one
submenu, the default values in
the other two submenus
change automatically.