User`s manual

158
Chapter 3 COAX SETUP
COAX SETUP
COAX SETUP
(1)(2)(3)
Notes:
* = Factory Default
Italicized items are available only when you
enable Admin User (in the PRINTER
CONTROL menu).
1
This menu appears only if the CTHI option is
installed.
2
This menu appears only if Port Type (under
C/T PORT) is set to Coax.
3
This menu appears only if the CTHI
emulation (under PRINTER CONTROL) is
set to Standard.
4
When in SPC Mode, the default is Enable.
Translation Tbl
(page 242)
Early Print Cmpl
(page 212)
SCS Buffer Cntrl
(page 235)
NL At MPP + 1
(page 228)
Disable*
(4)
Enable
On* Off
Primary Sets
See page 160
Secondary Sets
See page 160
Active Char Set
(page 196)
Secondary Set* Primary Set
Don’t Wait* Wait Until Done
PA1
(page 229)
PA2
(page 229)
Buffer Reprint
(page 201)
Coax Type
(page 208)
4234* 3287
Buffer Print
(page 200)
Disable* Enable
Alt. Set 80-9F
(page 197)
Printable* Control Code
Intervention Req
(page 224)
Send To Host* Do Not Send
CR At MPP + 1
(page 209)
On * Off
Continued at the top of next page
Position Aft FF
(page 230)
Off* On