User`s manual

MEDIA CONTROL Submenus
129
Print Direction and Orientation are two independent options that can be
combined to produce the following results depending on the Active IGP
Emulation:
The factory default is Head First when IGP/PGL or IGP/VGL is enabled.
The factory default is Foot First when PPI1 is enabled.
Tear-Strip Time
When Media Handling is set to Tear-Off Strip or when Media Handling is set
to Continuous and Continuous Mode is set to Tear Strip Full, Tear-Strip Time
specifies the number of seconds after the buffer is empty that the printer will
wait before it advances media to the tear bar position.
The range is .1-60.0 seconds, and the factory default is 1.0 second.
Pre-Peel Mode
• Disable.
• Enable. When using Peel-Off Media Handling, enabling Pre-Peel Mode
adds a forward and reverse motion to each label prior to printing. The
added forward pre-peel motion temporarily breaks the die cut label from
the liner, and the reverse motion places the label back on the liner prior to
printing, peeling, or dispensing the label. Pre-Peel Mode is usually
enabled only when using die cut labels with an aggressive adhesive that
makes automatic label removal from the liner difficult.
The factory default is Disable.
Table 4. Head First
Print Direction
Option
Orientation Option
Result in Active IGP Emulations
(IGP/PGL or IGP/VGL)
Head First Portrait Portrait
Head First Landscape Landscape
Head First Inv. Portrait Inv. Portrait
Head First Inv. Landscape Inv. Landscape
Table 5. Foot First
Print Direction
Option
Orientation Option
Result in Active IGP/PPI1
Emulation
Foot First Portrait Portrait
Foot First Landscape Inv. Landscape
Foot First Inv. Portrait Inv. Portrait
Foot First Inv. Landscape Landscape