User`s manual

83
DIAGNOSTICS
(page 200)
C/T PORT
(2)
(page 216)
Printer Tests
Test Count
Software Build
Hex Dump Mode
Print Error Log
Clear Error Log
DRAM Installed
Ptr On Time
Ptr Media Dist
Head Print Dist
Head On Time
Reset Head Data
Head Type
Head Voltage
Port Type
Device Address
Image Buf Size
Timeout
Report Status
PARALLEL
PORT
(page 204)
NOTES:
Italicized items are available only when you enable Advanced User (under PRINTER CONTROL).
1
Available only when the Centronics option is enabled (in the Port Type submenu of PARALLEL PORT).
2
Appears only if the CTHI option is installed.
3
Appears only if an Ethernet Network Interface Card (NIC) is installed.
4
Appears only if the IPDS emulation is installed.
5
Appears only if a NIC is installed.
SERIAL
PORT
(page 208)
Port Type
Baud Rate
Word Length
Stop Bits
Parity
Data Protocol
Buffer Size in K
Trickle Time
Timeout
Report Status
Data Term Ready
Request to Send
Poll Character
Poll Response
Idle Response
One Char Enquiry
Printer Status
Framing Errors
Port Type
Data Bit 8
(1)
PI Ignored
(1)
Buffer Size in K
Trickle Time
Timeout
Report Status
Prime Signal
Data Polarity
(1)
Resp. Polarity
(1)
Busy on Strobe
(1)
Latch Data On
(1)
ETHERNET
PARAMS
(3)
(page 218)
IP Address
Gateway Address
Subnet Mask
MAC Address
Novell Protocol
Nest Serv Type
NetBIOS Protocol
Novell Frame
ASCII Data Port
IPDS Data Port
(4)
Keep Alive Timer
Ethernet Speed
(5)
DHCP
Job Control