User`s manual

Restore The Printer To Operation
287
4. Press until “PRINTER CONTROL” displays.
5. Press ↑ until “Advanced User” displays.
6. Press + or - until “Enable” displays.
7. Press ↵ to select the “Enable” option. An asterisk (*) appears next to
“Enable.”
8. Press until “MEDIA CONTROL” displays.
9. Press ↓ until “Media Handling” displays.
10. Press + or - until the “Cut” option displays.
11. Press ↵ to select “Cut.” An asterisk (*) displays next to “Cut.”
12. Press ↓ until “Cutter Type” displays.
13. Press + or - until “Heavy-Duty” displays.
14. Press ↵ to select “Heavy-Duty.” An asterisk (*) displays next to
“Heavy-Duty.”
15. Relock the ↵ keybypressing↓ and ↵ at the same time, then press
PAUSE to put the printer back online.
16. If the bar code validator is installed, adjust the validator beam. (Refer to
“VALIDATOR” on page 84.)
17. Make sure any media sticking out of the platen goes in the cutter entrance
slot.
18. Test the printer cutting operation and print quality by selecting the
Diagnostics → Printer Tests menu and printing one of the test patterns.
(Refer to “DIAGNOSTICS” on page 200.)
19. To save the configuration parameters, refer to “Saving A Configuration”
on page 72.
Removing The Media Cutter
1. Set the printer power to O (OFF).
2. Pull the cutter assembly to the down (open) position.
3. Using the appropriate metric hex key, remove the two screws securing
the cutter bracket to the lower support assembly.
4. Unplug the RJ-11 connector from the RJ-11 receptacle.
5. Remove the media cutter from the printer.
6. Install the front door assembly on the printer lower support assembly.
.
.
.
.
.
.