User`s manual

Fault Messages
267
28 CU NOT ENAB Yes Controller Unit Not Enabled.
Poll time-out-error. The
printer was not polled for one
minute across a coax
interface.
Check the cable connection and host
system. (Refer to the line problem
determination procedures, as
recommended by the host system.)
33 HEAD OPEN
TIMEOUT
Yes Status message in the CT
emulation: The printer was
offline more than 10 minutes,
and the "Intervention
Required" parameter is set to
"Send to Host."
Close and latch the printhead. Press
PAUSE to put the printer online.
40V POWER FAIL Yes +40 VDC: an internal power
failure.
Power off the printer for 15 seconds,
then power back on. If the problem
persists, contact your authorized
customer service representative.
203 DPI Head Installed Yes Normal power-up message.
The printer is running its
initialization routine and
indicating DPI resolution of
the installed printhead.
No action required.
300 DPI Head Installed Yes Normal power-up message.
The printer is running its
initialization routine and
indicating DPI resolution of
the installed printhead.
No action required.
Table 15. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution