User`s manual

171
• On. Print Complete is sent immediately. The next page will be created.
This improves the print performance when starting the next page, but
degrades error recovery.
The factory default is Off.
Elong./Alt. Font
(From page 149.) Controls which host command sets elongated (double high)
fonts and extended character set.
• ELNG=BS (hex 08) FONT=SO (hex 0E)
• ELNG=SO FONT=BS
The factory default is Elng=BS Font=SO.
Emulation
(From page 136.) This menu item allows the user to select the desired IPDS
emulation, either 4028 IPDS or 3816 IPDS.
The factory default is 4028 IPDS.
Epson Set
(From page 154.) This menu item allows selection of the desired Epson
character subset used by the printer. The options are listed on page 154.
The factory default is ASCII (USA).
Error Markers
(From page 143.)
• Enable. Prints the following error markers for those elements that print
beyond the page boundaries:
>> for elements that begin off the right side of the page;
<< for elements that begin at the indicated position but end off the page;
♦ for elements where the starting position of the command contains an
error other than an off-page error.
• Disable.
The factory default is Enable.
Error Msgs
(From page 143.)
• Enable. Command syntax is checked and error messages printed when
command parameters are incorrect.
• Disable. Error checking and error messages are suppressed.
The factory default is Enable.