User`s manual

167
Character Set
(From page 145, page 150, page 152, page 154.) This menu item allows
selection of the character set to be used by the printer.
Cmd Resolution
(From page 143.)
• Low Resolution. Sets a low command resolution mode.
• High Resolution. Sets a high command resolution mode.
The factory default is Low Resolution.
Coax Type
(From page 128.) This parameter defines the printer emulation, as follows:
• 4234
• 3287
After the emulation has been changed, a POR status is sent to the host.
The factory default is 4234.
Code Page Subset
(From page 136.) This menu item allows the user to select the desired version
of the following code pages - 037,273, 274, 275, 277, 278, 280, 281, 282,
284, 285, 297, 500 and 871.
The options are Version 0 (the factory default) and Version 1.
Compressed Print
(From page 149.) Controls which host command sets compressed printing.
• Char 01 SOH
• Char 03 ETX
• Char 09 HT
The factory default is Char 01 SOH.
Control Code 06
(From page 146, page 149, page 151.) Control Code 06 defines the function
of ASCII code 06 hex (ACK). You can select an alternate line spacing of 6.0,
8.0 or 10.3 LPI.
The options factory default is 8.0 LPI.
Control Code 08
(From page 146.) Control Code 08 defines the function of ASCII code 08 hex
(BS). You can define the code to output an Elongated character or a
Backspace. The factory default is Elongated.