User`s manual

159
Auto Skip at End
(From page 129.) Specifies whether to perform an automatic form feed at the
end of a print buffer. If form feed is the last character in the print order, the
form feed function is supplied by the Auto Skip At End option.
• Off. Sets the printer to print at print position 1 of the next line.
• On. Sets the printer to print at print position 1 of the first line of the next
form.
The factory default is Off.
Auto Uppercase
(From page 140.) This parameter enables the printer to print text in all
uppercase when using the ALPHA command.
• Disable. The printer will print text in upper and lowercase.
• Enable. The printer will print text in uppercase only.
The factory default is Disable.
Autoeject (PGL)
(From page 141.) If the last page of a job is not full, that is, the data does not
fill the entire page, you can instruct the printer to eject the page or to stop and
hold the page at the last print position.
• Disable. The printer does not eject the last page unless you send a Page
Eject command or until the printer receives another print job.
• Enable. The printer ejects the last page after the entire job has been
processed and printed.
The factory default is Disable.
Autoeject (VGL)
(From page 142.) Determines paper handling upon exiting the VGL Repeated
Form and Dynamic Form commands.
• Disable. Holds the print position at the bottom of the form.
• Enable. Issues a form feed after the last form is printed so all pages will
be physically printed.
The factory default is Disable.
Autowrap
(From page 140.) This parameter determines if text will wrap to the next line
when the line of text exceeds the right margin.
• Disable. Truncates the text beyond the right margin until a CR or CR + LF
is received.
• Enable. Automatically inserts a CR + LF after a full print line.
The factory default is Disable.