Specifications

MEDIA SETUP Submenus

TOF Adjust Mode

• Disable (factory default). This option disables the “TOF Adjust” distance

set using the TOF Adjust menu (see TOF Adjust below).

• Enable. This option enables the “TOF Adjust” distance set using the TOF

Adjust menu (see TOF Adjust below).

TOF Adjust

This option sets the distance from the Top Of Form (TOF) that is left blank

(unprinted) after a label has been removed in Tear-Off Strip. Normally printing

is done starting at TOF, but when this mode is enabled the start position for

printing can be adjusted from 0.00 to 0.40 inches from TOF (in increments of

0.01 inch). This adjustment can be helpful if a die cut label sticks to the platen

by means of jagged edges created during removal of a poorly die cut label

when using the tear bar. By controlling how much blank space there is from

TOF, you can control how much the media is called back after it is torn off.

The factory default is 0.40 inches.

BackFeed Motion

This setting controlls when paper is fed back to the print position.

• Before (factory default). With this setting, paper is fed back to the print

sition immediately before printing.

• After. With this setting, paper is fed back to the print position immediately

after a job completes printing.

• None. With this setting, the paper will not be fed back to the print position.