Specifications

208
Chapter 6 Diagnostics for E0xx, Bad NVM, or ILL NVM Errors
MODE NOT COMPATIBLE
WITH CUTTER
Check Media Mode
Yes Peel-Off Media
Handling selection was
attempted with the
cutter option still
installed. This mode
requires that the front
door assembly be
installed to use the
Label Taken Sensor.
Select a different Media
Handling Mode.
MISSING PRINT
HEAD See Manual
Yes The printer does not
detect installation of the
printhead.
1. Install the printhead.
2. Install or reset the
printhead signal cable
and printer cable.
NOT ENOUGH
SPACE ON EMC
Delete EMC File
And Optimize
Yes There was not enough
room on the expanded
memory cartridge
(EMC) to save the
QCMC.
1. Cycle power, skip the
QCMC configuration
using the Cancel key.
2. Delete some files from
the EMC.
NOVRAM ERROR B Yes Printer firmware code
error.
1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and follow the
instructions on
page 186.
3. Contact your authorized
customer service
representative.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation Solution