Energy Star Instruction Manual

91
PARALLEL
PORT
(page 229)
SERIAL
PORT
(page 233)
Port Type
Baud Rate
Word Length
Stop Bits
Parity
Data Protocol
Buffer Size in K
Trickle Time
Timeout
Report Status
Data Term Ready
Request to Send
Poll Character
Poll Response
Idle Response
One Char Enquiry
Printer Status
Framing Errors
Offline Process
Port Type
Data Bit 8
1
PI Ignored
1
Buffer Size in K
Auto Trickle
Trickle Time
Timeout
Report Status
Switch Out On
Prime Signal
Data Polarity
1
Resp. Polarity
1
Busy on Strobe
1
Latch Data On
1
Offline Process
NOTES:
Italicized items are available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
1
Available only when the Centronics option is set to Enable (in the Port Type submenu of PARALLEL
PORT).
2
Menu shown only if Feature File has been loaded.
3
Available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
4
The presence of this menu depends on the LP+ Emulation selection (under PRINTER CONTROL).
5
These menus do not display when CT, TN5250, or TN3270 emulation is selected.
6
All three Form Length submenus work in conjunction. When you change the default in one submenu, the
default value in the other two submenus change automatically.
7
All three Form Width submenus work in conjunction. When you change the default in one submenu, the
default value in the other two submenus change automatically.
DIAGNOSTICS
(page 225)
Printer Tests
Test Count
Software Build
Feature File
2
Hex Dump Mode
Auto Dump
Print Error Log
Clear Error Log
FLASH Installed
DRAM Installed
Ptr On Time
Ptr Media Dist
Head Print Dist
Head On Time
Reset Head Data
Head Type
Select CPI
Select LPI
Typeface
Character Group
Character Set
Epson Set
Horizontal DPI
Vertical DPI
Prop. Spacing
Italic Print
Slashed Zero
Left Margin
5
Right Margin
5
Top Margin
Bottom Margin
Print Char. Set
Define CR code
Auto LF
Define LF code
Printer Select
20 CPI Condensed
Bold
Alt. Set 80-9F
Text Position
Host Command
Reset Cmd CFG Ld
Form Length (inches)
5, 6
Form Length (mm)
5, 6
Form Length (lines)
5
Form Width (inches)
5, 7
Form Width (mm)
5, 7
Form Width (char.)
5
EPSON FX
SETUP
3, 4, 5
(page 180)