Energy Star Instruction Manual

Appendix G

The PTX_SETUP Commands

ENGINE MEDIA_HANDLING Value Sets the type of media handling:

0 - Continuous

1 - Tear-Off Strip

2 - Tear-Off

3 - Peel-Off

4 - Cut

MIRROR Value Value of 0 turns mirroring off,

non-zero turns mirroring on.

MODE X Sets the print mode to Thermal

Transfer.

D Sets the print mode to Direct

Thermal.

WIDTH Value Sets the page width in 1/1000” units.

ODV 1 Enables the ODV unit so that ODV

begins verifying printed barcodes.

RFID OVERSTRIKE_REPORT ON/OFF Enables/disables reporting of RFID

overstrikes to the host. The default

is OFF (disabled).

STATISTICS_REPORT ON/OFF Enables/disables reporting of RFID

statistics to the host. The default is

OFF (disabled).

STATISTICS_CLEAR Clears the RFID statistics.

PRINTJOB START jobID Start of job marker. Results in a

“start of job” message sent back to

host through the PPM port when a

job starts printing.

END jobID End of job marker. Results in a “end

of job” message sent back to host

through the PPM port when the job

finishes printing.

Table 33. Thermal PTX_SETUP Commands

Command Sub-Command Parameter Description