Owner's manual

278
Chapter 6 Technical Information
(*) Pin 17 is connected to a number of through holes on the GPIO printed
circuit board. It can be used to supply power (via a user-installed resistor) to
the collectors of the output transistors. See the diagram of the outputs on
page 280.
Table 14 : Connector Wiring
1: IP1A 18: OP1C 34:R1CM
2: IP2A 19: OP2C 35:R2CM
3: IP3A 20: OP3C 36:R3CM
4: IP4A 21: OP4C 37:R4CM
5: IP5A 22: OP5C 38:R1NC
6: IP6A 23: OP6C 39:R2NC
7: IP7A 24: OP7C 40:R3NC
8: IP8A 25: OP8C 41:R4NC
9: IP1C 26: OP1E 42:R1NO
10: IP2C 27: OP2E 43:R2NO
11: IP3C 28: OP3E 44:R3NO
12: IP4C 29: OP4E 45:R4NO
13: IP5C 30: OP5E 46: n.c.
14: IP6C 31: OP6E 47:+5V
15: IP7C 32: OP7E 48:5Vret
16: IP8C 33: OP8E 49:+24V
17: (*) 50:24Vret