Owner's manual

186
Chapter 5 Patterns / Variables
Variable Tab
Use Variable tab to define variables. Use a variable to store data from the
host so that it can be used at a later time. To define a variable, enter the name
of the variable and add it to the Variable List. To store data into the variable
use the Store mode (
page 165). To clear the content of all defined variables
use the Reset All Variables mode (page 165).
Figure 168. Variable Tab
Name: The name of the variable. This name appears in pop-up menus where
you insert and use variables.
Variable List
Lists all the variables that you have defined and added to the list.
New: Click New to clear the Name field.
Add: Click Add to add the named variable to the end of the Variable List.
NOTE: The name of the variable must be unique.
Edit: Select an item in the Variable List, and click Edit to copy its name into
the Name field.
NOTE: If you select more than one item, only the name of the first item will
copy into the Name field.
Remove: Select one or more items in the Variable List, and click Remove to
remove them from the list.
IMPORTANT Removing variables invalidates entries that use the variables.