User`s guide

4-101
Printer, Plotter, and Spooler Subsystem Programming
Staples
The –y option controls whether staples are desired or not. Only
certain paper sizes are supported for each of the values for this flag.
Also, there are several rules about output quantities and
destinations. Refer to printer documentation for details on all the
possibilities. The valid values are:
0 no staples (default)
1 one staple (top left)
2 two staples (left side)
Job Offset
The –e flag controls whether offsetting the first page of each job in
the finisher bin is desired. The first page is offset toward the front of
the finisher by 1.7 inches. The offset function is ignored if staples are
not off. Separator sheets may be selected independently of offset.
The valid values are:
+ job offset ON
! job offset OFF (default)
Lexmark Optra E310 Laser Printer
Page Rotation
Page rotation selection is supported for the PCL 5 emulation by
using the –z flag of the qprt command.
–z 0 Portrait
–z 1 Landscape
Paper Source
Paper source selection is supported for both the enhanced PCL 5
emulation and the PostScript Level 2 emulation by using the –u flag
of the qprt command. The input source number is the same for both
PCL and PostScript:
–u 0 manual feed
–u 1 tray 1
By default, the banner and trailer pages come from the top tray. To
change the default, change the values for the uH and/or uT attributes
respectively in the colon file to the value for the desired paper
source. The valid values are the same as for the –u flag. Do this by
editing the virtual printer colon file by using the chvirprt command.