User`s guide

4-79
Printer, Plotter, and Spooler Subsystem Programming
Lexmark Optra Laser Printer
Paper Source
Paper source selection is supported for both the enhanced PCL (R)
5 emulation and the PostScript Level 2 emulation by using the –u
flag of the qprt command. There are several optional input sources.
The input source number is the same for both PCL and PostScript:
–u 0 manual feed
–u 1 tray 1
–u 2 tray 2
–u 3 tray 3
–u 4 feeder or feeder 1
–u 5 feeder 2
By default the banner and trailer pages come from the top tray. To
change the default, change the values for the uH and/or uT attributes
respectively in the colon file to the value for the desired paper source
(s0–S5). Use the lsvirprt command.
Paper Size
Paper size selection is supported by using either one or both of the
qprt command flags, –O and –Q. The –O flag controls paper versus
envelopes. A value of 3 indicates a paper size and 4 an envelope
size. Envelopes are only valid for manual feed, feeder, or feeder 2.
The default for –O is 3 or paper. The default for –Q is 1 or Letter for
paper sizes and Com 10 for envelope sizes.
Paper Sizes (–0 3)
Envelope Sizes (–0 4)
–Q 1 Letter 7 3/4 Monarch
–Q 2 Legal 9 (Com 9)
–Q 3 B5 paper 10 (Com 10)
–Q 4 A4 DL
–Q 5 Executive C5
–Q 6 A5 B5 Envelope
–Q 7 Other Envelope
Paper Type
The Optra printer supports paper types: rough, normal (default),
transparency, labels, and cardstock using the –y parameter of the
qprt command or the _y attribute in the colon file.
–y 1 Rough
–y 2 Normal (default)
–y 3 Transparency
–y 4 Labels
–y 5 Cardstock